MCU H7 FRAM µSD IMU × 3 BARO MAG WHOLE-BOARD HEATER BADDECK · CONCEPT
In development Made in Canada

Electronics

Baddeck Flight Controller

A larger, more capable flight controller, built for Canadian weather.

The bigger sibling of our Cygnet controller, built for Canadian weather. It pairs an STM32H7 processor with three time-synced IMUs and onboard logging. A whole-board heater brings the electronics up to temperature, so it is designed to cold-start at −50 °C. It targets both ArduPilot and PX4. It is named for Baddeck, Nova Scotia, where the Silver Dart made the first powered flight in Canada in 1909. Baddeck is in design now, so every figure below is a target.

Cold-start target
−50 °C
Time-synced IMUs
3
STM32H7 core
480 MHz
UARTs
8

Figures are Rev A design targets. Measured numbers, board size and the full pinout replace them after board bring-up.

Why it's built this way

Starts in a Canadian winter

A whole-board heater brings the processor, sensors and storage up to temperature before flight, so Baddeck is designed to cold-start in −50 °C air.

Steady sensors in the cold

Once it is flying, the heater holds the IMUs at a steady temperature, so gyro and accelerometer bias shift less as the air temperature changes.

Three IMUs, sampled together

Two ICM-42688-P and one industrial-grade IIM-42652, time-synced so the estimator can compare them and drop one that disagrees.

ArduPilot and PX4

Both open autopilots are targeted. No locked firmware and no vendor cloud. Parameters live in FRAM and full flight logs go to microSD.

Built on our own line

Fabricated and assembled in Ontario on the same in-house PCB line as the rest of our electronics, so revisions don't wait on an overseas fab.

Spares from the same line

We hold the design files, so spares, repairs and later revisions come from the line that built your board, not from whatever a distributor has left.

Specifications

Design targets (Rev A)estimated

Processor
STM32H743, 480 MHz, 2 MB flash, 1 MB RAM
IMUs
2 × ICM-42688-P + IIM-42652, time-synced
IMU range
±2000 °/s, ±16 g
Barometer
Bosch BMP390
Magnetometer
Bosch BMM150
Heater
Whole-board pre-heat for −50 °C cold start
Storage
FRAM (parameters), microSD (logs)
PWM outputs
8
Serial ports
8 UARTs
Operating temperature
−50 to +60 °C
Firmware
ArduPilot, PX4